Services
Home batteriesSolar + battery systemsSolar panelsAdd a battery to solarEV chargersMain panel upgradesAll services →
Areas we serve
San FranciscoSan FranciscoNorth BayEast BayPeninsulaSouth BaySee every city →
Resources
Service · Home batteries

Home battery installation in the Bay Area

Store your own solar for the 4 to 9pm peak and keep the house running when PG&E shuts off power. Sized from your real usage, installed by one accountable team.

[N] batteries installedCertified installer brands
BATTERY · GARAGE INSTALLBattery and gateway on a painted garage wall, conduit square to the panel, morning light from the door.
BackupWhole home or essentials
Works withNew, existing or no solar
Peak covered4 to 9pm, every day
Typical install[N] day on site
On this page

What is included

One crew, one warranty, one point of contact. Every battery installation includes the full scope below, itemized in your proposal.

  • Load analysis from 12 months of your PG&E interval data
  • Battery, backup gateway and all balance-of-system hardware
  • Essentials subpanel when partial backup is the better design
  • Structural and electrical design, stamped where your city requires it
  • Permits, inspection and PG&E interconnection, filed by us
  • App setup with backup reserve tuned to your rate plan
  • Manufacturer warranty registration
  • Workmanship warranty: [N] years

How a home battery works

A battery system has three parts. The battery stores energy. The inverter converts it between DC and the AC your home runs on. The backup gateway watches the grid and decides where power flows. Pick a moment of the day to see what happens.

Solar arrayProducing
GatewayRouting solar
Your homeSolar powered
BatteryCharging
PG&E gridSmall export credit
Solar powers the house and fills the battery first. Only true surplus goes to the grid, where NEM 3.0 credits it at a low rate.

Without a gateway, grid-tied solar must shut off during an outage, even at noon. That anti-islanding rule protects line crews working on the wires. The gateway is what lets your system disconnect safely and keep running while the grid is down.

How much battery do you need?

Battery size is two numbers. Energy, in kilowatt-hours, decides how long it lasts. Power, in kilowatts, decides how much it can run at once. A heat pump or well pump starting up needs power more than energy. Start from your goal.

Your goalTypical starting pointWhat it covers
Cover the evening peakOne battery, about 10 to 15 kWhMost 4 to 9pm use in an efficient home
Back up essentialsOne or two batteries and an essentials panelFridge, internet, lights, outlets, furnace fan
Whole-home backupTwo or more batteriesEverything, with heavy loads like EV charging managed
Typical starting points. Your interval data decides the final size.

Planning a heat pump or a second EV? Tell us now. Sizing for tomorrow's electric home costs less today than adding capacity later.

What a home battery costs

We publish ranges because an honest quote starts with one. Your exact price depends on your home, and your proposal itemizes every line.

One battery, installed$XX,XXX to $XX,XXX
Whole-home, two batteries$XX,XXX to $XX,XXX
Added to existing solar$XX,XXX to $XX,XXX

Before incentives. Ranges reviewed [Month Year].

What moves the price

  • Capacity and count. More kilowatt-hours cost more, though a second unit usually costs less per kWh than the first.
  • Backup scope. Whole-home backup can require a larger gateway or a main panel upgrade. Essentials backup may need a subpanel.
  • Your electrical panel. Many older Bay Area homes have 100A service. Some systems need more headroom, or a load-management device.
  • Install location. A garage wall near the panel is simplest. Long runs, exterior mounts and trenching add labor.
  • Permitting. Each city sets its own fees, review times and inspection rules.

See your price, not a range.

Address and bill in, sized battery and itemized price out.

Get my battery estimate

From first call to backup power

  1. Step 01

    Estimate

    Your address and bill in, a first design and price out.

  2. Step 02

    Site survey

    An engineer inspects your panel, wall space, roof and service capacity.

  3. Step 03

    Design and proposal

    Final layout, single-line diagram and backup plan, with all four ways to pay.

  4. Step 04

    Permits and installation

    We pull permits, install, and meet the city inspector on site.

  5. Step 05

    PG&E approval and handover

    Once PG&E grants permission to operate, we set your reserve and walk you through the app.

Batteries we install

We are brand-agnostic and recommend the unit that fits your loads, roof and existing equipment.

SpecTesla Powerwall 3Enphase IQ Battery 5PFranklinWH aPower 2
Usable capacity13.5 kWh5.0 kWh15 kWh
Continuous power11.5 kW3.84 kW10 kW
Solar inverterBuilt inSeparate microinvertersSeparate
Expands byExpansion units5 kWh modulesAdditional units
Best fitNew solar and battery, high powerEnphase solar homes, modular growthWhole-home backup, large loads
Per manufacturer datasheets. [Confirm against current spec sheets before launch]
Key takeaway
  • Under NEM 3.0, a battery turns cheap midday solar into expensive evening power.
  • Choose whole-home or essentials backup first. It drives size and price.
  • Size from your interval data, and plan for the electric home you will have.

Home battery FAQ

Can I add a battery to my existing solar?

Yes. Most systems can take an AC-coupled battery with no change to the panels. If you are on NEM 1 or NEM 2, adding storage generally keeps your existing plan, provided the array itself is not expanded. We confirm your plan's rules with PG&E before design.

How long will it last during an outage?

It depends on what you back up and the weather. A fridge, lights, internet and outlets draw far less than a heat pump or an EV. With solar recharging in daylight, essentials can keep running for days. Your design shows an estimate for your actual loads.

Can I get a battery without solar?

Yes. A standalone battery charges from the grid off-peak, then covers your evening peak and outages. Without solar it cannot recharge during a long outage, so we size it to your critical loads.

Where does the battery go?

Usually on a garage wall near the main panel, and many units are rated for outdoor installation. We follow the California Fire Code on location and clearances, which keeps batteries out of bedrooms and living spaces.

Is a home battery safe?

The batteries we install carry UL 9540 listings, and every installation is inspected by your city before PG&E allows it to operate. Placement, clearances and disconnects follow the fire code.

Does a battery need maintenance?

Very little. Software updates arrive over the air and we monitor battery health remotely. You see charge, backup reserve and outage events in the app.

Related services

All services →
Pairs with batteries

Solar + battery systems

Designed together, permitted once.

Already have solar

Add a battery to solar

Keep your NEM 1 or NEM 2 plan.

Often needed first

Main panel upgrades

More capacity for an electric home.

Keep the lights on through the next shutoff.

A sized battery plan for your home, free and without a sales call.

CallGet my estimate